Toshiba Paper Feed Kit ROL-KIT-FC30-U 3-Piece Roller Set for e-STUDIO 6LK50755000

Roller Set for e-STUDIO Cassette Pickup

The Toshiba paper feed kit restores reliable sheet pickup on compatible e-STUDIO copiers. Toshiba lists the assembly as ROL-KIT-FC30-U and 6LK50755000. The pack contains one pickup roller, one feed roller and one separation roller.

Each roller uses a rubberised tyre bonded to a moulded hub. The tyre compound grips plain and recycled stock without marking the sheet. The pickup roller lifts the top sheet from the cassette stack. The feed roller drives it forward, and the separation roller holds back the next sheet to block double feeds. All three parts wear at a similar rate, so Toshiba supplies them as one set.

Replacement follows the standard cassette service route. Pull the paper drawer out, release the roller retainers, and slide each roller off its shaft. Clean the shafts and the cassette feed opening before fitting the new parts. Seat each roller fully against its clip and rotate it by hand to confirm free movement. Run a test copy from each drawer afterwards to check for double feeds or skew.

Worn rollers show up as misfeeds, multifeeds and jams at the cassette. Operators often hear a slipping sound before the jam appears. Replacing all three rollers at once avoids a second service visit within weeks. Keep the pack sealed until fitment, because the rubber compound hardens when exposed to heat and sunlight over long periods. Store spare kits in a cool, dry cabinet away from ozone-producing equipment.

The set covers a wide model range across the 2008A, 2018A, 2505AC, 2515AC and 2525AC families. Confirm the machine plate and the cassette type before ordering, since large-capacity trays use a different roller set. A technician can complete the swap in under thirty minutes on most chassis.

Key Features

• Three-Piece Maintenance Set
  The pack ships with one pickup, one feed and one separation roller.

• Individual Roller Part Numbers

  • Feed roller carries part number 6LK50739000
  • Separation roller carries part number 6LK50742000

• Rubberised Tyre Compound
  The tyre grips recycled and plain stock without leaving surface marks.

• Clip-On Shaft Fitment
  Each roller slides onto its cassette shaft and locks with the original retainer.

• Cassette Feed Section
  The parts address jams and multifeeds at the paper drawer, not the bypass tray.

• Broad e-STUDIO Coverage
  Fits the 2008A through 6525AC mono and colour ranges listed in the compatibility row.

Specifications

What’s in the Box

• One pickup roller

• One feed roller (6LK50739000)

• One separation roller (6LK50742000)

Why Choose the ROL-KIT-FC30-U

• Buying the full set avoids a repeat service visit when the second roller fails.

• Rubber tyres restore grip on recycled stock that slips through worn rollers.

• Clip-on fitment needs no shaft adapters or special alignment tools.

• The set covers both mono and colour e-STUDIO chassis from one part number.

• Sealed packaging keeps the rubber compound supple until installation.