VGA Cable 10M SVGA HD15 Male to Male 3+6 Ferrite Gold Plated 1080p

Long-Run SVGA Monitor Lead for Projectors and Displays

The VGA Cable 10M is a male-to-male HD15 assembly for linking a PC, laptop, or dock to a projector, monitor, or wall plate across a long run. It uses a 3+6 conductor layout with coaxial RGB lines and separate sync pairs. Both ends carry a standard 15-pin D-sub plug with thumbscrews.

The coaxial RGB conductors run at 75 ohms to match the analogue video impedance of VGA ports. This keeps colour timing intact over the full 10 m span. The assembly carries 1920 x 1080 at 60 Hz, 1920 x 1200 at 60 Hz, and 1280 x 1024 at 75 Hz without visible ghosting on typical office displays.

Ferrite beads at each connector suppress high-frequency noise picked up along shared trunking. Foil and braid layers cover the signal bundle, and the PVC jacket measures 8 mm across. The cable weighs 780 g and tolerates 0 °C to 50 °C in ceiling voids and floor boxes. Gold-plated pins resist corrosion on contacts that stay mated for years.

Installers should avoid coiling the surplus length tightly behind a wall plate. A coil forms an inductor and can soften edge detail at 1080p. Route the slack in a loose figure-eight instead, and keep the run clear of mains cable where possible.

Key Features

• HD15 Male to Male Termination
  Both ends use a standard 15-pin D-sub plug with thumbscrews for tool-free fixing at the port.

• 3+6 Conductor Layout

  • Three coaxial lines carry red, green, and blue video
  • Six discrete conductors handle horizontal sync, vertical sync, and DDC data
  • Separate sync pairs reduce cross-talk against the video lines

• 75 Ohm Impedance Match
  The coaxial elements hold the impedance that analogue VGA transmitters expect across the full length.

• Dual Ferrite Cores
  Beads moulded at each connector absorb common-mode noise from nearby power and network cabling.

• Foil and Braid Shielding
  Combined shielding layers limit EMI ingress on long runs through shared containment.

• Gold-Plated Contacts
  Plated pins and sockets resist oxidation on permanently mated projector and monitor ports.

Specifications

What’s in the Box

• 10 m VGA HD15 male to male cable

• Protective connector caps

Why Choose This SVGA Lead

• The 3+6 layout keeps analogue colour timing stable across a full 10 m run.

• Ferrite beads and dual shielding protect the signal in shared cable trays.

• Gold plating holds contact resistance low on fixed projector installations.

• Thumbscrews secure the plug so the cable resists pull-out in ceiling mounts.

• An 8 mm jacket fits standard 20 mm conduit and floor box entries.

• The assembly needs no adapters or signal booster on 1080p office displays.

people also view

• CCTV Closed Power Supply 12V 10Amps
• OEM VGA Cable 3M HD15 Male-to-Male Double Shielded
• OEM VGA Cable 1.5M HD15 Male to Male
• OEM VGA Cable 5M HD15 Male-to-Male
• OEM VGA Cable 1.5M Male-to-Male HD15