Toshiba FR-KIT-3072 Fuser Maintenance Kit 6LK25732000 110V for e-STUDIO 207L 257 307

Fuser rebuild set for e-STUDIO copiers

The Toshiba FR-KIT-3072 maintenance kit restores the fusing unit on e-STUDIO 207L, 257 and 307 copiers. It carries part number 6LK25732000 and ships as a complete rebuild set. The package includes the heat roller, pressure roller, filter and five picker fingers. Toshiba rates the assembly for 300,000 pages at 110 V.

The heat roller uses a PTFE coating that releases toner without offset, and the pressure roller applies even nip force across the page width. The filter traps paper dust and toner particles before they reach the fuser inlet. Picker fingers separate the sheet from the roller surface after fusing. All parts match the original fit and finish for the 207L, 257 and 307 chassis.

Installation follows the standard fuser strip-down procedure for these models. Technicians remove the fuser unit, replace the rollers, filter and fingers, then reseat the assembly. No calibration or firmware update is required after fitting. The kit suits preventive maintenance schedules in office fleets and high-volume copy rooms.

Worn fuser rollers show up as gloss variation, offset toner at the page edge or paper that curls after fixing. A clogged inlet filter raises internal temperature and accelerates roller wear. Replacing the whole wear set at one time prevents a second strip-down within the same service interval. Check the thermistors and the fuser lamp while the unit is open.

Allow the fuser to cool before handling, because the roller reaches operating temperature above 180 °C. Wear lint-free gloves when seating the new heat roller and keep the PTFE surface free of grease. Confirm that the picker fingers sit square in their slots and that the pressure roller springs load evenly. Run a test print and inspect for offset, creasing or gloss banding before returning the machine to service.

Key Features

• Complete fuser rebuild set
  The kit bundles the heat roller, pressure roller, filter and five picker fingers in one package.

• 300,000-page yield
  Toshiba rates the assembly for 300,000 pages under standard fusing conditions.

• PTFE-coated heat roller
  The coating releases toner cleanly and resists offset at operating temperature.

• Even nip pressure
  The pressure roller applies consistent force across the page for uniform fusing.

• Dust and toner filtration
  The included filter traps particles before they enter the fuser inlet.

• Five picker fingers
  The fingers strip the sheet from the roller surface after each fusing cycle.

• Direct compatibility
  The kit fits e-STUDIO 207L, 257 and 307 copiers without modification.

• 110 V rated assembly
  The fuser components are specified for 110 V machines in the e-STUDIO range.

Specifications

What’s in the Box

• Heat roller

• Pressure roller

• Filter

• 5 x picker fingers

Why Choose This Toshiba Fuser Kit

• One kit supplies every wear part needed for a full fuser rebuild on the 207L, 257 and 307.

• The 300,000-page rating matches the preventive maintenance interval on supported chassis.

• PTFE-coated rollers resist toner offset and extend service life between rebuilds.

• The included filter protects the fuser from dust and toner contamination.

• No calibration or firmware step shortens printer downtime after installation.

• Genuine Toshiba part number 6LK25732000 matches service documentation for direct ordering.

people also view

• OEM 1U Metallic Cable Manager
• Toshiba Canvio Advance 2TB Portable External Hard Drive USB 3.2 Red
• Toshiba Canvio Basics 1TB External HDD USB 3.2 Gen 1
• Toshiba Canvio Advance 2TB External Hard Drive USB 3.2
• Fellowes PrivaScreen 4802001 15.6-inch Widescreen Privacy Filter 16:9